yard sign stake full
Tips for Installing Plastic Yard Signs onto Sign Stakes
Installing corrugated yard signs onto sign wires is not very difficult.  Your sign wires should insert relatively easily.  If you follow these simple sign stake installation instructions, the installation will be a breeze.

 

   
 24 x 18 inch Corrugated Plastic Yard Sign with tick mark 7 inches from sign edge.  Sign wire inserted into flute of 4 mm corrugated plastic yard sign.

When mounting corrugated plastic yard signs to sign stakes we recommend making a small tick mark on the bottom of the sign.  For 24 x 18 inch signs make two small tick marks 10 inches apart (10 inches is the width of a standard H fame).  An easy way to do this on a 24 inch wide sign is to measure in 7 inches from each side and make a tick mark at each location.  This will leave two marks spaced 10 inches apart.  (For an 18 inch wide sign measure in 4 inches from each side).

After making the marks line up your both legs of your sign wire with the corresponding flute and push the wire in.  Use caution when handling sign wires they can be sharp and often have an oily coating one them, your hands may get dirty (a little soap and water will clean your hands up).

Note:  First of all, installing sign wires is not very difficult.  Your sign wires should insert relatively easily.  The wires are approximately 10 inches apart, you may have to make slight adjustments to your measurements due to manufacturing tolerences.  If the guide marks are not made properly the signs will be difficult to mount and may crease your sign.

For more information or to purchase sign wires and yard sign stakes, visit or online store at SignOutfitters.com